Call for papers :

Submission Last Date 28/02/2018
Status Notification Within 2 Days
Submit Paper Online

Check Paper Status

Paper Status

News & Updates

IJAERD provides Hard Copy of Published Certificates of Publication to each author.

We have started accepting articles by online means directly through website. Article submission link is given on left side

IJAERD Provide Review card, Acceptance Letter and Fee Receipt without taking any extra charges

IJAERD invites research paper from various engineering disciplines for Vol.1 Issue 12 (Dec. - 2014) issue,

Conference Proceedings

National Conference on Emerging Trends in Computer & Electrical Engineering (ETCEE - 2014) March 7-8, 2014, Organized by Atmiya Institute of Technology and Science, Rajkot

National Conference on Recent Research in Engineering and Technology (NCRRET-2015) organizing by Dr. Jivraj Mehta Institute of Technology, Mogar-Anand

National Conference on Emerging Trends in Computer, Electrical & Electronics (ETCEE - 2015), March 13-14, 2015, Organized by Atmiya Institute of Technology and Science, Rajkot

Paper Details

Paper Title
Effect of Process Parameters on Strength of Fused Deposition Modelling
Abstract
Additive Manufacturing (AM) technologies have been emerged as a fabricationmethod to obtain engineering components within a short span of time. Desktop 3D printing, also referred as additive layer manufacturing technology is one of the powerful method of rapid prototyping (RP) technique that fabricates three dimensional engineering components. In this method, 3D digital CAD data is converted directly to a product. In the present investigation, ABS + hydrous magnesium silicate composite was considered as the starting material. Mechanical properties of ABS + hydrous magnesium silicate composite material were evaluated. ASTM D638 and ASTM D760 standards were followed for carrying out tensile and flexural tests, respectively. Samples with different layer thickness and printing speed were prepared. Based on the experimental results, it is suggested that low printing speed, and low layer thickness has resulted maximum tensile and flexural strength, as compared to all the other process parameters samples.
KeyWord
FDM; Additive Manufacturing;Rapid prototype; 3D printing; Tensile Strength; Flexural Strength; Mechanical Properties
Others Details
Paper Id : 31640
Author Name : Akshay Shrishrimal
Co-Author Name(s) : Pranav PatilPrathamesh Patil
Volume/Issue No : Volume 05 Issue 02
Page No : 38-44
DOI Number : DOI:10.21090/IJAERD.31640
Publication Date : 2018-02-07
License : This work is licensed under a Creative Commons Attribution 4.0 International License.
website : http://www.ijaerd.com/index.php
Impact Factor : 4.72, SJIF-2016
ISSN Details : eISSN: 2348-4470, pISSN:2348-6406