Machine Improvement For Machining Half Shaft (fixture)

Authors

  • Milind Balasahbh Jadhav Mechanical Engineering Department, Guru Gobind Singh Polytechnic, Nashik, Maharashtra, India
  • Shubham Pramod Saraf Mechanical Engineering Department, Guru Gobind Singh Polytechnic, Nashik, Maharashtra, India
  • Rohit Sanjay. Aher Mechanical Engineering Department, Guru Gobind Singh Polytechnic, Nashik, Maharashtra, India
  • Shubham Mohan Hagawane Mechanical Engineering Department, Guru Gobind Singh Polytechnic, Nashik, Maharashtra, India
  • Neeraj Anil Kukreja Mechanical Engineering Department, Guru Gobind Singh Polytechnic, Nashik, Maharashtra, India

Keywords:

Interchangeability, Special Purpose Machine, Facing, Centering, Changeover,Half Shaft , Yoke Shaf

Abstract

The yoke shaft is machined on SPM machine.The half shaft can be machined on same SPM machine by
improving certain elementary parts.Before our project, this machine is employed for machining of yoke shaft (20-RY1788202).But customer also require the machining of half shaft (17-NY-1768202) which is similar to construction of
yoke shaft.The half shaft had smaller diameter and longer linear length that of yoke shaft.

Downloads

Published

2017-03-25

How to Cite

Milind Balasahbh Jadhav, Shubham Pramod Saraf, Rohit Sanjay. Aher, Shubham Mohan Hagawane, & Neeraj Anil Kukreja. (2017). Machine Improvement For Machining Half Shaft (fixture). International Journal of Advance Engineering and Research Development (IJAERD), 4(3), 595–598. Retrieved from https://ijaerd.com/index.php/IJAERD/article/view/2135

Issue

Vol. 4 No. 3 (2017): Volume 4 Issue 3 March 2017

Section

Articles